A+ A A-

I. Introduction:

\(\bullet\) This 10 Bus Test Case is taken from the text book of Glover et al. [1]. It is given as a design project to the students.
\(\bullet\) This test case consists of 10 buses, 7 generators, 5 transformers and 6 loads. Also, the system has three voltage levels as follows: 22 kV (2 buses), 230 kV (6 buses) and 345 kV (2 buses).
\(\bullet\) It is modeled under \(S_{base}=100 \ \text{MVA} \ (3\phi)\), and bus 1 is considered as a swing bus.
\(\bullet\) The required system data is as follows:

II. Single-Line Diagram:

\(\bullet\) The single-line diagram of the proposed system - as taken from the book - is shown below:

III. Files:

No file available yet...

IV. References:

[1] J. D. Glover, M. S. Sarma, and T. J. Overbye, Power System Analysis and Design, 5th ed. Stamford, CT: Cengage Learning, 2012.

Real time web analytics, Heat map tracking